STAGE 119

 Return to the BUILD


“In this stage, you fit two speakers to the partition wall rear panel, as well as installing the rear ceiling panel.”

 

Contents


Parts

Materials: All of these parts are plastic.

Magazine – Issue 32

  • Model Instructions
  • Haunted Honeymoon: Wendy Goldman on her Deleted Scene
  • Michael Chapman: Ghostbuster II‘s Late Cinematographer
  • The Ecto-1 Gurney: How Ray Modified the Original Gurney
  • Ecto-101: The Seed

Build


Partition Wall Speakers

Step 01

Retrieve your Body assembly from the previous stage and place it upside down on a soft surface.

Remember, take special precautions to protect the Deck Lights on the roof of the Body!

Fit the Rear Ceiling Panel into the rear area of the roof as shown and align the screw holes. Then, secure this Panel into place with four (4) EM screws.

This is your friendly reminder to try using 3-in-One Oil on all screws going into metal:

Step 02

Fit the keyed post of the Partition Wall Speaker Left into this matching hole at the top left corner of the Partition Wall Rear Panel.

The two Partition Wall Speakers are marked ‘L’ and ‘R’:

These Speakers should be fitted into the side of the Rear Panel with the recessed screw holes, as shown:

Secure this Speaker into place from the other side with one (1) QP screw:

In the same way, fit the keyed post of the Partition Wall Speaker Right into this matching opposite hole of the Partition Wall Rear Panel:

Secure this Speaker into place from the other side with one (1) QP screw:

I found these two stickers included with this stage, however there is no explanation of if/how they are used. I just stored them in my screw box:

Thoughts


These Speakers did not exist on the car used in the Ghostbusters film. It is likely these exist in the model because an entire Sony entertainment system was added to the restoration car which was then captured by Eaglemoss. I will likely remove them before we install this Partition Wall.

Next Up


Stage 120 – Partition Window, Partition Wall Panels

Leave a Reply

Your email address will not be published. Required fields are marked *