STAGE 62

 Return to the BUILD


“In this stage, you fit the rear right interior panel as well as fitting the speaker.”

This will be a near identical process to the previous stage.

Contents


Parts

Materials: Everything in this stage is plastic.

Build


Rear Right Interior Panel & Speaker

Step 01

Fit the keyed post of the Rear Right Speaker into the matching hole of the Rear Right Speaker Base:

Secure these together from behind with one (1) EP screw:

Step 02

Fit the rear posts of this Speaker Base assembly into these matching holes in the Rear Right Interior Panel, as shown:

Secure the Speaker Base into place from behind with two (2) more EP screws:

Step 03

Retrieve your Cargo Area Floor assembly from the previous stage. Fit this Rear Right Interior Panel assembly along the top right side of the floor, aligning the three lower posts into the matching holes as shown:

Secure the Rear Right Interior Panel to the Cargo Area Floor from below with three (3) DP screws:

As I mentioned in the previous stage, these speakers (and the boxes they are in) are not original parts and did not exist in the films. Therefore, I chose to remove them from my build. The holes left behind do not bother me, but I did use black electrical tape to cover the holes to block any light from the taillights from coming through them:

Thoughts


This stage should have felt familiar as we just did the left panel. Still, it is progress!

Next Up


Stage 63 – Rear Left Component Station, Latitude/Longitude Processors, AN/UNH-6 Sound Reproducer

Leave a Reply

Your email address will not be published. Required fields are marked *