Return to the BUILD
“In this stage, you attach plating and wire covers to the front left fender and body frame.”
Contents
Parts
Materials: The Front Left Fender is metal, but the rest of these parts are plastic.
Build
Front Left Fender Plating & Wire Covers
Step 01
Fit the Front Left Fender Inner Plating to the inside of the Front Left Fender, aligning the screw holes as shown:
Secure the Front Left Fender Inner Plating into place with three (3) BM screws.
This is your friendly reminder to try using 3-in-One Oil on all screws going into metal:
Step 02
Retrieve your Body Frame assembly from the previous stage. Fit the two Wire Covers to these locations on the inner left side of the Body Front Frame, and secure them with two (2) EM screws (one for each), as shown.
These Wire Covers have slots in them, so I decided to drive these screws in halfway first:
Then, I slid the covers into place and tightened the screws:
Thoughts
This was a nice short and simple stage. The chrome trim on the fender looks nice!
Next Up
Stage 75 – Front Left Fender Plating, Unity S6 Spotlight, Switch Cover