Return to the BUILD
“In this stage, you fit the two left rear windows, as well as the associated window frame.”
Materials: The Window Frame Center Skirting is metal and the Left Rear Windows are plastic.
Left Rear Windows & Skirting
Retrieve your Left Rear Window Frame from the previous stage. Remove the adhesive backing paper from the Window Frame Center Skirting and gently fit it to the window frame, as shown:
Retrieve your Body assembly from Stage 88. Fit the two Left Rear Windows into these matching openings at the left rear, as shown.
These windows should fit flush into the openings. On my model, there was some flashing (bits of extra plastic around the edges) that I needed to slice off with my hobby knife so they would sit flush:
Fit the Left Rear Window Frame over the windows, aligning its posts into the matching holes of the body as shown:
Secure the bottom edge of the Left Rear Window Frame to the Body with three (3) VM screws.
NOTE: The two forward VM screws installed here will be replaced with new countersunk WM screws in Stage 108:
Carefully turn your Body assembly upside down on a soft cloth. Then, continue securing the Left Rear Window Frame into place from the inside at the forward edge with two (2) VP screws, as shown:
Finish securing the Left Rear Window Frame into place from the inside at the rear with three (3) AP screws, as shown:
The tinting of these side windows is inconsistent and has a few flaws, but the real car is from the 80s. I can accept a few deteriorated parts.
Stage 91 – Right Front Door, Rear View Mirror Support, Door Handle/Hinge/Cover, Ghostbuster Logo